Project cases
Four documented industrial moisture projects show the plant conditions, installation route, operating logic and measured results behind an online moisture system.
Project cases
Conveyor control, coal blending, bale inspection and truck receiving require different baselines, validation plans and decision rules. Each scenario follows the question the process team must answer at that measurement point.
Cement and mineral processing
01A typical MW-3000 through-material project for moving cement and mineral raw mix.
Published · 2026-08-10
Coal and bulk minerals
02A representative MW-3000 coal-conveyor project that keeps belt state, depth and density with the signal.
Published · 2026-08-10
Recovered paper and fibre
03A typical MW-6000 recovered-paper and fibre-bale project with repeatable scan coverage.
Published · 2026-08-10
Full-truck incoming inspection
04A typical MW-7000 project combining full-truck scanning, vehicle geometry and a retained receiving record.
Published · 2026-08-10
Validation status
Each project states the measurement route, the paired reference data behind the numbers, the decision rule in routine use and the boundary conditions that were validated. A new site establishes its own target band and response rule with the same evidence sequence.
Share the material, measuring position and decision you need to make. The first review is handled directly on WhatsApp.