Recommended conditions and intended use

Multi-section incoming-material assessment for commercial settlement and quality control.

01

Full-truck incoming loads

02

Recovered-paper or wood-chip projects

03

Agreed vehicle position and scan sections

04

Quality or settlement use under written rules

System configuration

Documented components; confirm the ordered configuration

Seven official product systems cover online process sensing, incoming-material inspection and continuous product analysis, with configurations adapted to material and installation conditions.

01Microwave transmitter probes
02Microwave receiver probes
03Left and right ultrasonic probes
04Industrial computer
05Temperature-compensation sensor
06Dedicated truck and bale software

Installation, validation and supply

Influential variables and project boundary

MW-7000 produces a sectional view of the scanned load, not a complete measurement of every inaccessible zone. Vehicle position and speed, load profile, section coverage, distance and temperature compensation, density variation and abnormal loads must be included in the validation and exception plan. Reference sampling and an independent acceptance set are required before supplier grading or settlement. The main brochure uses conflicting component codes on its system-composition and specification pages; neither set is an orderable identifier until a formal model list resolves the conflict. Final hardware quantities, software, integration, traffic works and service scope follow the order.

Inside the measurement route

How this system fits into a working production line

Multi-section incoming-material assessment for commercial settlement and quality control.

01

Measurement principle and represented volume

MW-7000 builds a sectional moisture view of an incoming vehicle load instead of relying on a few visible surface points.

02

How installation conditions influence the result

Define vehicle positioning, scan sections, traffic control and the meaning of missing or inaccessible zones before using the result for supplier or settlement decisions.

03

Signal, status and process context

Transmit the moisture value together with engineering units, valid and fault states, product or recipe identity, calibration version and timestamp. Align the value with transport delay before it reaches trends, alarms, PLC logic or quality records.

04

Calibration, acceptance and maintenance

Collect reference samples across the expected operating range, keep a separate acceptance set and record the installed geometry. Routine checks should cover sensor condition, reference residuals, invalid states and changes in material, density, temperature or product format.

The model name identifies a platform, while the working solution is defined by its transmitter or sensor option, controller, mechanical arrangement, signal interfaces and calibration. Product performance therefore remains linked to the supplied configuration and the application range demonstrated during validation.

Project cases

Where this system is already applied

Review the installation conditions, decision route and commissioning results for this model.

All blog articles

Related engineering guidance

Production applications2026-08-09

Truckload moisture inspection: make multiple sections represent the incoming load

One cross-section cannot automatically represent an entire truck. A receiving system needs defined vehicle geometry, section coverage, reference sampling and rules for incomplete or abnormal loads.

2 min readRead article

Production applications2026-08-09